Install and test against AEM UEGO and. Cfr download rct3 for free. Gauges with Bosch LSU 4.2 wideband O2 sensor that lets the. Timer, obd port, PLX devices, drag race.

1. Wideband Kit
2. Plx Wideband O2

So i just got my plx dm-6 gen 4 wideband combo and will be running a narrowband simulation with link but had some questions. How many have put the wide band in the stock o2 location without problems. When tapping into the o2 pin for the ecu can i just pull the wire back or do i need to cut it and splice. Wheres a good place to run the wire from the wide band to the module inside the car 4. Where should i pull power from. When using a narrow band simulation i only need to use the wideband input correct.

When using a resistor for the o2 heater wheres a good location to put it. Ive searched and coulndt find direct questions to my particular answers. I have mine in the front 02 spot, no issues.

If you're worried about heat, you can make a copper heatsink really easily. That's what I did.

I used these sheets: 2. You don't need to cut the wire if you can pull the sheathing back enough. Make a small X cut in the rubber boot around the steering column on the firewall and run it through there. Any 12v source.

Wideband Kit

Try finding the wire to the cigarette lighter, that's always a good one. Wire the 5v output of the wideband to the front o2 pin on the ecu (pin 4 on 1g). Enable narrowband simulation in link, then set the switch point to 2.35 according to this: I don't know about number 6. I have mine in the front 02 spot, no issues. If you're worried about heat, you can make a copper heatsink really easily. That's what I did.

Plx Wideband O2

I used these sheets: 2. You don't need to cut the wire if you can pull the sheathing back enough. Make a small X cut in the rubber boot around the steering column on the firewall and run it through there. Any 12v source. Try finding the wire to the cigarette lighter, that's always a good one. Wire the 5v output of the wideband to the front o2 pin on the ecu (pin 4 on 1g). Enable narrowband simulation in link, then set the switch point to 2.35 according to this: I don't know about number 6.